$129.00 USD
$299.00 USD
$349.00 USD
$679.00 USD1. Remove the existing toilet seat by locating the bolts and nuts, typically under a plastic cover, and removing them first.
2. Close the water supply valve and flush the toilet completely so that there is little to no water left in the toilet tank.
3. Disconnect the water hose from underneath the toilet tank.
4. Connect the 7/8" T-valve to the toilet fill valve where you just removed the water hose. Make sure the rubber washer is properly seated and the narrow side is up.
5. Attach the water supply hose that comes from the water shut off to the bottom of the T-valve.
6. Connect the metal hose we supplied to the open side of the T-valve.
7. Place the bidet on the toilet with the mounting brackets over the mounting bolt holes. Make any needed adjustments to center the bidet on the toilet. You should see the mounting bolt holes through the mounting brackets of the bidet.
8. Place the toilet seat back on the toilet over the bidet and secure the bolts down so that the seat and bidet attachment are stable.
9. Connect the hose from step 6 to the bidet water connection underneath the handle of the Elite3.
10. Slowly turn the water supply valve back on and check for leaks and test the unit for functionality.
11. If there are no immediate leaks, check again in about 5-10 minutes and your Elite3 is ready for use!
Call 727-537-9066 if you need more help!
1. Remove the existing toilet seat by locating the bolts and nuts, typically under a plastic cover, and removing them first.
2. Close the water supply valve and flush the toilet completely so that there is little to no water left in the toilet tank.
3. Disconnect the water hose from underneath the toilet tank.
4. Connect the 7/8" T-valve to the toilet fill valve where you just removed the water hose. Make sure the rubber washer is properly seated and the narrow side is up.
5. Attach the water supply hose that comes from the water shut off to the bottom of the T-valve.
6. Connect the hose we supplied to the open side of the T-valve.
7. Place the plate and guides over each mounting hole. Insert the mounting bolts through the plate and mounting holes.
8. Slide cone packing and washers onto the bolts, then fasten to securely mount bidet seat to toilet.
9. Slide the bidet seat onto the catch plate, centering the unit with the guide arrows on the base. You will hear a click one the seat is securely mounted. Center seat on toilet bowl and tighten the nuts on both bolts.
10. Connect the flexible tube from the T-valve to this product. Open water valve. Check for leaks.
11. Electric bidet seats* If there are no leaks and the surrounding area is clean and dry, connect the power cord to a ground protected power outlet.
Call 727-537-9066 if you need more help!
